You are here

STM32F7-discovery 3D Box 3D print or Lazercut

You can find the drawing for lazer cutting house or for 3D printing here

You remove the spacers from the stm32 board and mount them on the back panel with 4 pcs M3 * 6mm screews

Take the stm32 board and place it on the spacers and above that the 3D spacers part with the WIDE side upwards ...see the top of the picture

The you place the top part with the WIDE side in the BUTTOM and use 4 pcs M3 * 12mm screews...Do NOT tight them, only let the have the first or second tread.

Then you mount the front and back site and tigthed the screews.....Job Done



Recent comments

No comments available.